Commercial message, kind of -- I know of no other way to get this
message out to the Triumph community.
We are putting together an order for Southwick aluminum hubs. We must
have orders for 20 pairs in order to make the run, because we must
purchase an entire bar of aluminum for the run and it is quite
costly. These are made only about once every two years.
The advantages of these hubs are 1) stronger, 2) lip seal on inner
side, 3)heavier duty Timken bearings, 4) choice of stud size for the
competition minded.
The set of hubs consists of two aluminum hubs, your choice of wheel
stud length and diameter, all new Timken bearings of heavier design
than originals, inner lip seals, and dust caps for the outer ends.
The price will be $450, shipping point Coal Valley, Illinois.
you can see these at
www.tonydrews.com
click on "Jack's Parts"
Please email me off list if you want to be on the purchase list.
Thanks.
uncle jack
------------------------------------------------
No Virus Found In This Message
Scanned at barracuda.geneseo.net
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|