For those of you that have TR6's with the air injection rail on the exhaust
manifold, how did you "restore" that portion of the exhaust system? If I use
the OEM 1976 exhaust manifold, It has the air injection ports tapped into each
exhaust runner on the manifold with a threaded pipe fitting which then feeds a
common pipe or rail. All of this air injection system attached to the exhaust
manifold is discolored and rusty looking from 30+ years of high heat
conditions. Would you ceramic coat all of it? Or just media blast them the
air injection components? Obviously, removing the air injection system and
plugging the tapped holes in the manifold is one solution, but at this point, I
prefer to keep it OEM. If I were not going OEM, I would ditch the OEM
manifold for a header.
thanks, Greg H
---------------------------------
Everyone is raving about the all-new Yahoo! Mail beta.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|