Re: [TR] Silent block replacement - was Grease seals

[DLylis@aol.com]

I did.  I put a socket on the washer closed side down that was the  same 
outside diameter so that the pressure would be distributed evenly and not  to 
the 
center.  2nd try I ran a hand reamer backward through the hole so as  to wear 
rather than cut, polished the bush and the press pushed it in at about  1000 
lbs.  Done.  Thanks
 
David  Lylis
69 TR6 CC26160L
60 TR3A TS74461LO


===  This list supported in part by The Vintage Triumph Register
===     http://www.vtr.org