> I have the old bush removed and cleaned up and
> ready to
> install the new silentbloc bush. I have put this in my arbor press but am
> hesitant to put the pressure on as the joint between the taper pin and the
> bush
> is bonded rubber and deflects a bit. I do not want to get it in there but
> tear the rubber.
There should be a metal washer at the top that limits the deflection as you
press it into place. Press on the washer above where it contacts the sleeve,
and all should be well. That limited amount of deflection should not harm the
rubber bond.
Randall
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|