Thanks Ray,
One more question. The silentbloc bush between the idler arm and the
steering arm was sloppy. The rubber had "perished" in the bonded bush. (the
drivers side between the drop arm and the steering arm is ok must have been
replaced at some point). I have the old bush removed and cleaned up and ready
to
install the new silentbloc bush. I have put this in my arbor press but am
hesitant to put the pressure on as the joint between the taper pin and the
bush
is bonded rubber and deflects a bit. I do not want to get it in there but
tear the rubber.
What is the proper technique to get this bush into the steering arm?
David Lylis
69 TR6 CC26160L
60 TR3A TS74461LO
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|