Yup, I did mine after a complete rebuild with a 1/4" grade 8 shouldered
bolt. Used an undersized drill bit and it fit snugly also used red
loctite on that nut. drill at a 90* to the stock one and thats pretty
much it.
-jim
'76 TR6
http://home.centurytel.net/~jimbar
William C. Quincy wrote:
> Greetings Listers,
>
> Some time ago I read about a clutch fork mod that seem a good idea if
> you had the fork exposed fore some other reason. It was suggested to
> drill a hole through the fork and shaft, install a 5 mm bolt and
> nylock nut to insure reliability. Is this a good idea? If so, could
> someone please elaborate on the details.
>
> Thanks
>
> Bill Quincy
> Wichita Kansas
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|