Actually if there is a triumph club close by you could contact them to see
if anyone has a Churchill hub puller. The Churchill hub puller willpop it
off in about 10 seconds. You would never belive it was on as tight as it
was. I worked on getting my hubs off for two days before contacting our
local club. A member had the puller and pop it off in about 10 seconds. It
was embarrassing. The hub puller cost to much to buy but most local clubs
have a member who has one and these guys are usually more than willing to
help.
Happy Motoring
Jerry
-----Original Message-----
From: owner-triumphs@Autox.Team.Net [mailto:owner-triumphs@Autox.Team.Net]
On Behalf Of ghamilton99@comcast.net
Sent: Monday, December 04, 2006 11:12 AM
To: Terry Geiger; jim hearn; triumphs@autox.team.net
Subject: Re: [TR] Rear axle issue
Jim:
I agree with Terry, I would certaily check the hub nut first, but it is more
likely the bearing. Take his advise & buy a rebuilt hub assy or have it
done at a competent machinist. You need some where's near a 12 ton press to
get that baby apart, plus the right support around the housing to avoid
breakage.
Keep us posted.
--
Gary J. Hamilton
-------------- Original message --------------
From: "Terry Geiger" <tgeiger@shoalsbritishcars.org>
> Jim,
>
> This normally is an indication that the bearing in the rear hub is shot.
> Rebuilding the hub isn't really a DIY job but replacing it with a rebuilt
> hub is. You can purchase rebuilt units on an exchange basis from the usual
> suspects (Moss, TRF, British Parts Northwest, etc.).
>
> Terry Geiger
> '74 Triumph TR6 | '63 Triumph Herald | '74 MGB | '84 Mercedes 300D Turbo
> Diesel
> http://www.shoalsbritishcars.org/
>
> ----- Original Message -----
> From: "jim hearn"
> To:
> Sent: Monday, December 04, 2006 12:21 AM
> Subject: [TR] Rear axle issue
>
>
> >I was hearing some light banging on my right rear on bumps, jacked up my
> >'74
> > TR6 and I found a small amount of in and out movement on the right rear
> > wheel. The left side feels tight. I am hoping that it is the nut loose
> > holding it on the taper. Is that likely or is it more likely something
> > else? Thanks for any help, Jim
>
> Your messages not reaching the list?
> Check out http://www.team.net/posting.html
>
> === This list supported in part by The Vintage Triumph Register
> === http://www.vtr.org
>
> === Help keep Team.Net on the air: http://www.team.net/donate.html
>
> === unsubscribe/change address requests to majordomo@autox.team.net
> === Archives at http://www.team.net/archive
> === http://www.team.net/the-local
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.409 / Virus Database: 268.15.6/568 - Release Date: 12/4/2006
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.409 / Virus Database: 268.15.6/568 - Release Date: 12/4/2006
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|