Well, I've taken a look at the shims:
http://i12.photobucket.com/albums/a241/AdrianJones34/Shims.jpg
As you can see, there are 4 of them - the top two have a crease, no breakage.
Should I go ahead and replace them or just sandwich them between the 2 good
ones?
The combined thickness (as measured with a vernier caliper) is 1/16" (Can't
find the set of micrometers I had). I'm guessing, by the flexability, that
they are one each of the 4 different sizes that are sold by the Big 3 ie.,
0.006. 0.008, 1/64 and 1/32.
I was just going to order up a 1/32 to go with the (good) original 1/32.
Does that sound reasonable or do I need to more concerned and get these
properly measured.
Needless to say I didn't measure the float (?) before I dismantled.
Regards, Adrian TS58324
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|
