> The "correct" tool is a large allen wrench (1/2" ??). However, a
> cheaper alternative is to take the MC to your local hardware
> store and
> ask to see their selection of coupler nuts. These are 1"
> long nuts that
> are used to connect threaded rods together. Find one that
> fits the MC
> and use it and a wrench to remove the nut from the MC.
Or, buy a proper hex key from McMaster-Carr. ISTR the MC takes a 7/16",
which is $2.51. Even a 1/2" short-arm key is only $3, or you could splurge
and get the long-arm variety (still less than $5).
Note that the coupling nuts @ your local hardware store are usually only
Grade 2, only slightly harder than cold butter.
Randall
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|