On Wed, 8 Nov 2006, Todd Bermudez wrote:
> Joe,
>
> Remove the reservoir & you'll see this 1/4" hex bolt
> in there. Best bet is to go to a hardware store & get
> the proper 1/4" allen head wrench. I've tried to use
> a nut on then end of a bolt with little luck.
1/4"?
Isn't it a 1/2"??
All the ones that I've done have a 1/2" set screw. I even have a piece of
1/2" hex bar stock that I use for the job.
I must have "special" units. :-)
> Cheers,
>
> Todd Bermudez
> CD198L
> CF25768UO
regards,
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-linux-help |
Voice:617-253-7438 FAX: 617-258-9535 | Cell: 339-927-4489
------------------------------------------------------------------------------
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|