Yes , thats me, It was fuel in the oil from a leaking fuel pump. I
have a new crankshaft which I will have balanced and checked and will
install with standard size bearings. Id love to find standard
vandervell, but I havent found any yet. Thanks for you help. John
ZinkZ10C@aol.com wrote:
> I'm pretty sure AE , Vandervell , Clevite are now all owned by ACL from
> Australia. I've used all of these brands in various engines without trouble.
>
> Do you have the engine that went 400 miles after a rebuild and it started to
> knock? If so make sure you find the root cause of the failure otherwise it
> will fail again. Remember, the other half of the bearing is the crank. Both
> must be in good condition ( round ) for everything to work properly.
>
> Harold
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|