They will have the standard badge bar attachment points at the bottom of the
badge (with 2 holes). If you can figure out a way to attach to the grill
using those holes, I guess anything is possible.
I think grill badges typically have some sort of studs on the back which
these will not have. I suppose if there is enough interest, another
production can be done with the normal grill badge mounting
Joe
-----Original Message-----
From: THOMAS FANSHER [mailto:tfansher@comcast.net]
Sent: Sunday, October 29, 2006 6:36 AM
To: Joe Curry
Cc: Triumphs list
Subject: Re: [TR] More on Bumper Badges
Joe, can these be used in grills, or only on badge bars. I have a badge bar
for the TR3, but not for the 4 or the Stag. So a problem exists. If the
badges can be mounted to the grills, I need three. If only to badge bars, I
need only one.
And you can start taking orders for TR4 and Stag badge bars ;^)
TIA
Tom
61 TR3A
62 TR4
73 Stag
Subject: [TR] More on Bumper Badges
The size will be 3" in diameter with a standard base
for mounting on badge bars.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|