I believe the "micropolish" technique this guy uses is an immersion/agitation
in graded compounds. It makes the aluminum alloy look nice. I do not know if he
drills out the old worn out cast-in-place shaft bushings (I am talking about
the H series carbs here) and puts in new shaft bushings, this is the most
important part of the rebuild IMHO. It is the hardest to do and requires
specialized tools. I have been in Joe Curto's shop and have seen his work and
bought tools from him and he has done first rate work for me. I suggest you ask
the paltech guy about the shaft bushings and how he handles this. If he says he
just changes the shafts and does not drill out the bushes then you should go
elsewhere no matter how pretty the carbs look.
-rich-
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|