Folks,
I installed a new stainless exhaust on the 4A....solid axle system with 2 rear
mufflers.. falcon system w/ original style clamps. Problem is the leaks
around the clamped connections. For example where the double pipe enters front
muffler and the connection to to the y - pipe behind the center muffler. The
clamp connections are snug, but the leaks are substantial. I used a bit of
anti-seize on the connections but that's it....thought that the connections had
enough overlap, but limited due to rear muffler attach points and length of
pipes on the individual components
Should I use a sealant on and around the flanges? If so what kind. Also,
was concerned about overtightening the clamps and wonder if I need ome sort of
band clamp behind the rear muffler as the combination clamp/hanger connected to
the rear transmission mount does not seem all the effective.
Is there an exhaust system 101 step that I am missing? Anyone have the same
problem, if so what was necessary to stop the leaks?
Thanks
Mike Godley
65 TR4A
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|