For some reason I'm getting all my List mail but anything I try to reply to
or post goes in to cyberspace never to be seen again!
Frank Fisher is the blanking plate guy and his email is FGFO1@aol.com. And
now that I look at my web site, I gave Frank credit for machining the plate
but no way to contact him, so I'll be adding his email address to my site.
Bob Danielson
1975 TR6
http://tr6.danielsonfamily.org
-----Original Message-----
From: owner-triumphs@autox.team.net [mailto:owner-triumphs@autox.team.net]
On Behalf Of Bob Labuz
Sent: Thursday, September 21, 2006 2:46 PM
To: Terry Smith
Cc: triumphs@autox.team.net
Subject: Re: [TR] TR3A Fuel Pump Blanking Plate
On Wednesday 20 September 2006 08:24 pm, Terry Smith wrote:
> Hello, everyone.
>
> A few months ago, I seem to remember, someone had TR3A fuel pump
> blanking plates available.
>
> Are there any of these left out there?
>
> Terry Smith, '59 TR3A
> New Hampshire
>
Terry,
I just saw a listing on EBAY. But I cant find it today.
The guy who makes them is Frank Fisher out of California. BUt I cant
remember his email address. Take a look at Bob Danielson's web page on
tr6.danielsonfamily.org. Send Bob an email. He had Frank make the plates for
the TR6 also. He may have Fanks email address. The plates are very well made
and go for 20 $ or so on EBAY but he was offering them for 10$ to any list
member. I have 2 one for my TR4 project and one for my 58 TR3A. Very nice
fit.
Good luck,
Bob
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.1.407 / Virus Database: 268.12.6/453 - Release Date: 9/20/2006
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|