When reassembling the gears on the mainshaft, the article at:
http://www.vintagetriumphregister.org/maintain/TransRebuild/TRTrans02.pdf
says on page 6 to install the front synchro hub with "the large boss
forward". On looking at the hub, one side has a boss that sticks out
farther, but is of a smaller diameter, and the other side has a boss that is
of a larger diameter but not as deep.
So, one could take the "large boss" as being either side, depending on
whether "large" refers to depth or girth.
Could someone please advise which way this hub goes?
TIA,
Jim Wallace
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|