Had it back apart, replaced a gear, getting good at undoing that awful
circlip, etc.
Back together, being careful, and voila! it works through all the gears, and
reverse. Time for celebration? - well, not quite...
As we start to slowly lower it onto the overdrive, there comes a point where
something binds, so back off it comes to be examined, and now it has the
same symptoms as last night:
-neutral and fourth seem to work like fourth i.e. the output turns at the
same rate as the input, and any in other gear it just locks up (almost;
there is a little play)
-first motion shaft and mainshaft are not binding
-no synchro cups are stuck
Stumped, and frustrated.
Any ideas? Remember, it was working well, and now something has
changed...and I did not take anything apart between working and not
TIA
Jim W
2TS81417L (with TR4a tranny)
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|