attacked the last of the rot today. the old battery box came out quick and
easy, leaving a nice surround.
putting the new box in required putting the top in first and then a gentle
persuasion with a mallet to get the front in. all pretty easy.
BUT, the angled part of the box, (the part that has the body & chassis
number plates and where the ground strap ataches) is bent too far. about 1/4 to
5/16 toward the inside. thus the part that ataches to the top lip does not
touch
either.
its a genuine British Heritage part, or so the sticker says.
its now back out.
so:
do I put blocks and clamps on it and pull it to shape now?
if I do will it still go in?
or is it the intent to get it into place and then hammer and dolly it?
the hammer and dolly will not look that good when I'm done.
what did you guys do?
thanks as always
Frank Fisher
58 TS41366L
Temecula
California
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|