> When I took the rear brake cylinders off the car the dust seals were
> not present (probably rotted out in the barn). My original Haynes
> appears to show the seal between the backplate and under the cylinder
> slide-in locking fittings. The Moss catalogue shows the seal over the
> top of those fittings. Which is correct? If it is over (per Moss)
> then the opposite end from the handbrake lever would appear to just
> flap in the wind.
The lever end doesn't stay in place so well either. In this case, I believe the
Haynes (and the factory workshop manual) got it right.
Randall
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|