Thanks Bob...Actually I think I will have to try that route as I think that
the floor pans were replaced and welded to the gearbox cover.
----- Original Message -----
From: <kinderlehrer@comcast.net>
To: "Chris Bohn" <cbohn@sidepipe.com>; "Ed Oot" <eoot@citlink.net>;
<triumphs@autox.team.net>
Sent: Thursday, August 10, 2006 3:40 PM
Subject: Re: [TR] Heat from tunnel
>I glued the foil heatshield to the underside of the carpet. It does
>interfere somewhat whith the carpet lying flat, but it does seem to help
>prevent my knee from getting buned. I didn't want to put it on the
>underside of the tunnel because I figured the foil woult get torn and the
>foam would soak up a lot of oil and dirt.
> Bob
>
> -------------- Original message ----------------------
> From: "Chris Bohn" <cbohn@sidepipe.com>
>> Ed,
>>
>> I glued foil heatshield to the underside of the gearbox cover on my 4A,
>> foil
>> side out. Works well at reflecting the heat back and gives sound
>> insulation
>> as well.
>>
>> Chris
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|