Re: [TR] Convertible Top Installation

["Kinderlehrer" <Kinderlehrer@comcast.net>]

> I did my hood stick cover a little differently. After marking the spot the 
> receiver was to go, I used a hole punch to put a hole in it. I then used a 
> spare lift the dot stud through the hole to center the top part of the 
> receiver while locating the spots for the tiny slits to push the tabs 
> through. It worked well for me, of course, the material is probably a lot 
> thinner than Everlast.
> Bob


===  This list supported in part by The Vintage Triumph Register
===     http://www.vtr.org