> I'm getting ready to replace the stator tube on my TR3 and re-center the
> steering wheel and was wondering if anyone could tell me the size
> of socket
> I'll need to remove the steering wheel nut?
All I can remember is that it's big, and fairly unusual. 1-3/16" maybe ???
But unless you know the wheel has been moved on the shaft, and have an
earlier car without the "split" column, there is no need to remove that nut.
The steering is normally centered by adjusting the tie-rods. And the turn
signal head is centered to the steering wheel with the 3 grub screws on the
backside of the wheel.
Randall
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|