In a message dated 7/17/2006 9:03:11 PM Central Standard Time,
dorpaul@negia.net writes:
> The seal (Moss #66 on their steering page) is non-exisitant on my exisiting
> steering. I think it is an 'O' ring or 'draught excluder'. Of course, I
> intend to replace it (i THINK). It goes between the Idler lever and Idler
> bracket. My real question is how do get the lever out of the bracket? The
> diagram shows it as threaded so I am afraid to pull it.
>
The idler just unscrews from the mount, just like the trunions. And I just
got that seal from the Roadster Factory. The new one is rubber and my old one
was felt. If you really want felt you can buy some felt and cut one. Rubber
is fine with me.
Cheers
Dave
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|