> Any ideas on the fuel gauge.
Make sure the gauge itself is grounded. I believe the factory originally
installed a jumper from one of the gauge mounting posts to the ground tie point
in the dash panel, but it's frequently missing and not shown in any diagrams.
But the TR2/3 fuel gauge (unlike the later gauges) will not work properly
without a ground.
> I have one wire from the harness. Sending unit has
> two electrical connections. (???).
Most likely a ground for the sending unit. Look at the top of the unit, it
should be obvious. Here I'm not sure if Triumph originally installed a ground
wire or not, but IMO it's a good idea. Mine goes to one of the gas tank
mounting bolts.
Randall
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|