Terry Smith wrote:
>Does anyone have suggested procedures for getting the upper and lower seals
>into the lock-grooves in the windshield frame? ...Has anyone used silicone
>grease or silicone spray to give the rubber a helping hand?
>
I probably used dish soap as a lubricant, as I recall sliding it in
wasn't to difficult. It helps to stretch the seal quite a bit as you
pull it thru -- this make it skinnier. Once it pulled thru it will
relax to it original profile.
>Lastly, where does one insert the top seal to start, ...at the bottom, working
>it up one side and then over the top?
>
Now when I read that ('up one side') I wonder if I'm even thinking of
the same seal you are.
Geo H
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.394 / Virus Database: 268.9.8/380 - Release Date: 6/30/2006
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|