Hello, everyone.
As I looked to hook up the vacuum advance on my '59 TR3A, I find no place to
connect it to at the carburetor end. The Moss diagram on page 25 of ther
catalog shows a "union" that goes on the front carb underneath near the bolt
base. This part number--371-100--is listed as NA. My carb has a flat bolt
there with no connector. Come to think of it, I did have a bag of parts from
when I picked the car up in the shed where it had been stored for 30 years,
and there were some vacuum hoses loose there, but none attached when I
dismantled the car.
Is the vacuum advance is supposed to connect under the front carb?
Uhm, but when I look at page 84 of the Moss catalog at the distributor
diagram, I see two chjoices for vacuum line for the non-rubber vaccuum advance
model I have, and one of these shows a vacuum line adaptor, part number
378-240, which is available, but doesn't show where on the carbs that it hooks
up to.
Help! I'm operating in a vacuum!
Terry Smith
New Hampshire
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|