In a message dated 6/19/2006 11:43:23 AM Pacific Standard Time,
frede.thomas2@verizon.net writes:
Anyone having trouble with the choke being hard to pull open is because the
cable is run and connected improperly, check Bob Schallers book "More B/S
About TR'S and he covers the correct installation. The fork on the end of
the
choke rod goes on the ==inside== of the ==jet lever== the pin/cable clamp
then
goees through the jet lever then through the fork, as washer and a cotter
pin,
the fork ==does not== go between the jet lever as it would appear to, why do
you think the connecting pin # 39 is so long, these parts are listed in the
Moss cataloge as follows, # 33 # 36 # 37 # 39, so 37 goes completely inside
and not through # 33. "FT"
Thanks for the advice!
That is likely my problem. I have gone through all the stuff Randall
suggested many times.
Best, Mike Moore
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|