In a message dated 5/14/2006 1:11:06 PM Central Standard Time,
mgodley@tiac.net writes:
> When checking the operating lever adjustment. I found that no amount of
> tightening of the bolt/nut will keep the the lever from spinning on
> theoperating shaft..even to the point where the two halves of the lever
> touch..preventing further movement The shaft does not appear to be stripped
>.....but the
> diameter of the levers "bore" is to large...maybe that has enlarged or
> stripped over the years..who knows
>
Sounds like the lever has streached. A new lever may fix the problem. For a
quicker turn-around you can enlarge the gap at the open end of the lever with
a cut-off wheel on your Dremel(R) roto tool.
Dave
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|