In a message dated 4/27/06 9:26:21 AM Eastern Daylight Time,
dncullig@us.ibm.com writes:
<< No matter how long it's left, it will eventually shrink
to the point where one clip won't do the job. >>
Are these seal strips pre cut or are they extra long and trimmed to fit?
I'm not familiar with this exact appliaction but if it is anything like the
seals used on flat glass aluminum vans there is a trick. If they are trim to
fit, they are probably being streched during install and relax to original
length later. The trick here is to measure what is needed, add a 1/2 inch or
so
then make sure all of the rubber is used.
Harold
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|