In a message dated 4/11/2006 6:02:34 PM Central Standard Time,
jimbpps@cox.net writes:
> Looking at a pair of the intake ports, the two outer edges of the gasket
> miss covering the hole in the head by ~3/16 inch. Then in the 'center',
> between the two holes, the gasket sticks into the intake air/fuel stream
> ~1/8 inch!
>
Mark is on the right track. The intake ports were moved when they made the
change from the CC series engine to the CF series. It sounds like you have a
gasket for a 73 - 76 model TR6.
Or it could be for the 2000 cc motor.
Or you have a head from a CF series motor.
Check for port alignment between the gasket and the intake manifold as well.
This will tell you if your manifold matches the head.
Dave
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|