Thanks Vance, I had the same concerns. When you put the door glass
rubber strip on, did you trim it at all? If I roll up the window with
the door closed, the rubber tubular part is outside the glass. If I
close the door with the glass up, the window is outside the door glass
seal. Is that correct? Thanks, John
Navarrette, Vance wrote:
> John:
>
> FWIW, I set mine up to come up on the outside of the finisher.
>If it comes up underneath, then opening and closing the door with the
>window up seems to put a lot of stress on the glass, and I was worried
>about chipping and breakage. I don't know if that is factory correct or
>not though....
>
> Vance
>
>-----Original Message-----
>From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net] On
>Behalf Of John Mitchell
>Sent: October 02, 2005 6:00 PM
>To: 6-Pack; triumphs@autox.team.net
>Subject: Side window alignment
>
> I just put my windshield back on the TR6 and am getting the side
>windows aligned. Should the front corner of the side windows come up
>under the little rear extension of the windshield finisher or to the
>outside of them. If someone could take a look, Id appreciate it. John
>Mitchell 76 TR6
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|