<<There's an entire driveshaft on
eBay at the moment, no bids at $10 when I saw it.
>>
And the "parts" alone are worth that, folks!!!
And BTW, I SERIOUSLY recommend that if you have never done the u-joints
since YOU have owned car; take to an automotive machine shop with parts
(trust me, they will not mind<G>) in hand and request that they do the job
WHILST you watch!!! (and learn<G>)
Then have the assemble thing balanced.
First time might cost you $30 - $40 but is WELL worth it!!
Also (in some frames of mind??), it is best to mark the trans/rear end
flanges vs shaft flanges prior to removing shaft.
And ALWAYS replace nuts (lock washers when used) and nuts (be they NyLocs,
steel Locs or plain) with REAL Grade 5 hardware.
Regards.................
Ed
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|