Dave:
I needed to replace the Door Striker Plate and the Door Latch Assembly on my
early (read January) built '59 TR3 and was able to buy them from MOSS
Motors. I have not yet assembled them but the quality looks to be good with
only a slight variation in design on the Door Latch Assembly.
Scott Suhring
Mechanicsburg, PA
'70 TR6
'59 TR3
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net]On Behalf Of Dave1massey@cs.com
Sent: Tuesday, September 20, 2005 7:40 AM
To: frede.thomas2@verizon.net; danb@thelittlemacshop.com;
triumphs@autox.team.net
Subject: Re: TR3 doors
In a message dated 9/19/2005 4:31:08 PM Central Standard Time,
frede.thomas2@verizon.net writes:
> I just gave Mr Runyon at "TRF" a original set of "inner door wood frames"
> so
> they can be duplicated now as needed . "FT"
>
Thanks, Fred. How about the latches? The TR3 latches had a post that
allowed the release cable to be run outside the door trim whereas the 3A ran
the
cable behind the trim panel. Are the latches available?
Dave
|