> I know this is absolute heresy and I deserve nothing but contempt
> from the list for this answer, but then since I'm a masochist that's okay.
Bet you're a lot of fun in the dentist's chair, Jack !
> Now promise not to tell anybody, but if you forget about the cam
> bearings turning (which never happens) you can grind the little
> nubbin off the end of the bolt and install it and not worry about the
> washer thickness.
I agree the bearings aren't likely to turn. But IMO it's still important to
make sure the holes line up, since if the retaining hole isn't lined up, there's
a good chance that the oil hole isn't either. Especially important on the
rearmost cam bearing, since it also feeds oil to the rocker shaft (if it's
installed right).
Not contempt at all, just my $.002 ...
Randall
|