> On a TR4A there are two holes in each lower wishbone assembly that do
> not have a bolt running through them.
I assume you are talking about the holes nearest the inner pivot, which have a
stud for the spring pan rather than a bolt.
> Instead, they have some rubber plug to fill them up. (I guess to prevent
> water from getting into the arm).
I've checked my TR4A factory SPC, and workshop manuals. I don't see any signs
of plugs in those holes. My guess is that, just like the earlier TRs, the holes
were simply left open. They seem to rapidly fill with oil & dirt anyway, I've
never seen corrosion in those holes.
> Does anyone know where to find these?
You could just fill the holes with silicone caulk or "form a gasket" ...
Randall
|