| To: | spridgets@autox.team.net, triumphs@autox.team.net |
|---|---|
| Subject: | Finsihing a walnut dash board |
| From: | SDOliner@aol.com |
| Date: | Tue, 12 Jul 2005 11:03:51 EDT |
I am trying to get a nice finish on a walnut dashboard. Yesterday I applied three coats of Miniwax High Gloss Clear Quick Drying polyurethne, with a small foam rubber brush. Th finish is too uneven I can easily sand it out and start all over again. or just rub down the high spots in the finish. I was thinking of trying something in a spray can. Suggestions? David Oliner |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: coil question, Geo Hahn |
|---|---|
| Next by Date: | Re: coil question, Philip E. Barnes |
| Previous by Thread: | coil question, Philip E. Barnes |
| Next by Thread: | Re: Finsihing a walnut dash board, Philip E. Barnes |
| Indexes: | [Date] [Thread] [Top] [All Lists] |