In a message dated 6/16/2005 12:07:23 AM Central Standard Time,
dkspence@telus.net writes:
> Trying to correct a misfire that starts around 2800 rpm. Point gap is
> set to 16, static timing at 12 BTDC idle at 875-925 rpm. Dwell meter
> says 25 degrees. What is the procedure to adjust to the speced 35
> degrees?
>
Point gap should be closer to 10 (0.010) as I recall. At any rate, close the
points down a little bit and take a reading. Repeat until the desired 35 deg
is achieved.
Then reset your timing 'cause it will change.
Dave
|