If what your asking the clearance between the block and the dist
housing. You can add gaskets to obtain the clearance or in rare cases
you could resurface the oil pump bushing which would allow the dist
housing to drop a bit more.
-jimb
Ray Tedder wrote:
>On the TR6 engine rebuild, I would like to know what the clearance was
>between the Distributor Pedestal and the Distributor Drive. If it is
>greater than the .003 how did you correct it.
>
>
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.11.12 - Release Date: 5/17/2005
|