On Tue, 26 Apr 2005, Mark Hooper wrote:
> I have heard on a feww occasions where the set screw has come out in the
>valve train. That;s the screw holding the rocker shaft in place on the
>rearmost pedestal. If it comes loose, there is a 1/8" hole exposed in the oil
>flow. That has a fair impact on idle pressure I believe, but problably not too
>much at higher RPMs.
>
> Mark
Right - good point. Loosing that screw is similar to losing clearance at
the cam - the oil feed is directly off the rear main bearing .
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-linux-help |
Voice:617-253-7438 FAX: 617-258-9535 | Cell: xxx-xxx-xxxx
------------------------------------------------------------------------------
|