> I'm replacing the standard starter motor with a high performance unit (Edge
> brand - came with no instructions) but I'm not sure about wiring. Original
> has 3 wires/connections - battery, white/red (to ignition switch) &
> white/yellow (to coil?). New unit has 2 connections - battery and one spade
> connector. What do I do with the white/red & white yellow? Connect one and
> not the other??
The white/yellow (to the coil) should be tied back and insulated, unless you
want to retain the "cold start boost" function by adding a relay. The white/red
(from the switch) can go to the terminal on the starter solenoid.
Randall
|