Paul Dorsey wrote:
>I rebuilt my TR3's front end replacing bushings, rubber, etc. Now I am
>having
> trouble reassembling the lower wishbone arm's tight enough so that the
> spring
> pan will mount up to the lower wishbone arms. The two studs on the lower
> wishbone arms only lack 1/8" from being close enough so that the spring
> pan
> can go in the two holes on the engine side of the spring pan.
--------------------------------
Paul, it's been two years since I did this. ...But is it possible one of
the inside thrust washers is backwards? I seem to remember they are flat on
one side, but have a nub on the other of about an 8th inch?
Terry Smith
New Hampshire
'59 Tr3A
|