In a message dated 2/15/05 6:05:10 PM Eastern Standard Time,
markvaden@gmail.com writes:
> Is the male snap for the rectangular tab get mounted on the
> wheel well?
>
Trying to help here. I think you have the three forward snaps correct. The
rectangular tab snap gets snapped on the "Back Panel".
The rear top cover has 2 flaps on the bottom with 2 brass rings on
each flap. What does this connect to?
These connect to the studs that should be on the floor directly below the
back panel. The carpet with lift a dot fasteners go over top.
The cloth webbing on my top bows is currently held in place with the
screws that attach the longer lift the dot connector. This works now
because I have no panel kit installed. How is the webbing supposed to
attach to the back of the car? Does it use a lift the dot connector,
and then the top lift the dot connector just sits on top of it?
That would be correct.
Hope this helps,
Darrell
62 TR4 CT 5521 LO
|