I am sorry I seem to be using a lot of bandwidth here over the last
couple of days.
I was looking at the driver's seat pan in the sun light today &
noticed there are cracks emanating out several inches in all
directions from the back bolt holes on both sides of the seat. If
the seat were not covered I would braze some reinforcing metal there,
but since it is covered I was thinking I need someone with a arc
welder or a spot welded to tack the reinforcing materials on to the
bottom of the seat.
Is this a common problem??
Does my solution seem reasonable???
Thanks
John
John A. Wise, Ph.D., CPE
5483 W Potter Dr
Glendale, AZ 85308
(+1)(623)376-9632
Wise@erau.edu
1960 TR3A TS80422L
http://home.earthlink.net/~johnwise/TR3A.html
|