Amen to that! That is a great document!!
Jim Bauder
-----Original Message-----
From: owner-triumphs@Autox.Team.Net
[mailto:owner-triumphs@Autox.Team.Net]On Behalf Of CarlSereda@aol.com
Sent: Wednesday, January 12, 2005 4:29 PM
To: ScharfR@aol.com; january@chemeketa.edu; barteet@mrl.ucsb.edu;
paulwillou@socal.rr.com; tcodman@eabishop.com; triumphs@Autox.Team.Net
Subject: Re: "Motor Trader" TR4 Supplement
Thanks Bob,
I thought I'd seen all the TR4 stuff and then you share such a nice piece as
the '1962 Motor Trader Service Data #393' with us.
No one in the past 5 years has been able to tell me factory specs on TR3-4
cylinder head valve spring 'strengths' (it's not in any of the books I have)
and
yet finally ... here it is!
Fitted load:
Auxilliary spring (exhaust only): 10lb.
Inner spring: 33lb.
Outer spring: 38lb.
Thanks for sharing this document.
ps; I've never seen this rendition of the 'TR4 Wiring Diagram' either - it's
not the same drawing as Factory or Owner's manual..
Thanks again,
Carl
'63 TR4 since '74
<< TR4 Fans:
Here's the file. I thought I'd better get the first couple of batches out
rather than fall too far behind. Hope you all enjoy it.
Bob Sharp
Michigan
64-ish TR4 >>
|