Bill,
That is what I did with my TR3 W/S Wiper Mounting Hardware Kit. There was NO
WAY that I was going to get those grommets in those holes! I split the
grommets with a razor knife and put it all together. That was about 5 years
ago and the wiper assembly still looks and works great!
Good luck, and as always, YMMV!
Jim
Jim Bauder
'58 TR3 (Sold and delivered!)
'68 TR250 (Project Started!)
Scottsdale, AZ
-----Original Message-----
From: owner-triumphs@Autox.Team.Net
[mailto:owner-triumphs@Autox.Team.Net]On Behalf Of Bill Brewer
Sent: Thursday, December 30, 2004 7:19 AM
To: triumphs@Autox.Team.Net
Subject: TR3 Wiper Motor Mounting Kit
I am mounting the wiper motor on my 1960 TR3A. I ordered the mounting
kit
from TRF. My question is the rubber mounting grommets. It has a groove in it
that looks like it should somehow fit through the hole in the mounting base
with half of the grommet on top and half on the bottom, but it looks
impossible to do. Should I cut the grommet in half and put half on the
bottom?
It doesn't look like the whole grommet should go on top. What have other
listers done?
Bill Brewer
Tehachapi, California
|