I have a set of drawings supplied by a frame alignment machine manufacturer
in the early '60s lots more detail than the charts in the Workshop Manuals I
have seen. Send me your snail mail address and I will mail you a copy.
Unfortunately, I don't have them in digital format!
They came from Dennis Lambert, a sometimes list member!
Regards,
Jim Bauder
Jim Bauder
'58 TR3 (Sold!)
'68 TR250 (Project Started!)
Scottsdale, AZ
-----Original Message-----
From: owner-triumphs@Autox.Team.Net
[mailto:owner-triumphs@Autox.Team.Net]On Behalf Of Andreas and Jim
Sent: Saturday, December 18, 2004 10:11 PM
To: triumphs@Autox.Team.Net
Subject: TR Dimensions
Is there such a thing as a plan showing the dimensions of a TR Chassis.
Specifically the disatance between points for a TR2, 3, 4 Chassis.
Jim Vass
1962 TR4
|