RE: SU H6 rebuild

["Frank & Sandy Crowe" <thecrowes@hotmail.com>]

I recently rebuilt the SU's on my Tr3 - I found my throttle shafts were worn 
about .012" or better, but the bodies were just about normal and round.  My 
choke was not working well at all either.

I didn't like the finish on the new shafts or jets, so polished them up 
quite a bit with some steel wool.  Soaked the cork seals in water (read that 
somewhere) and lubed the throttle shafts with some MOS2 just for kicks.

All seem to be working great - so far!

Frank
   TR3a - TS55223L
    Doretti #20 (with TR3 engine)