> I'm taking the lower wishbone arms and new bushings
> for trunnion end to machine shop soon. I know the
> bushings need to be reamed after being pressed into
> arm, but to what spec? I am reusing the trunnions
Why, pray tell ? Why pay all that money to replace the bushings, and then
put worn trunnions in them ?
> I have a suspision that the trunnion extensions might
> be off a bit from spec tolerances. Should I just have
> the machinist mic each trunnion extension and ream to
> that dimension for the corresponding arm?
Nope, the trunnion pins will not have worn round. Just have him ream the
bushings to nominal (can't recall offhand if it's 5/8" or 11/16").
Randall
|