1960 TR3
Based on input from a few people on the list I attempted to set the push rod
clearance in both the master cylinder as well as the slave cylinder. One
thiing I noted was that prior to doing anything, my pedal only goes in about
2".
I continued on and when I was bleeding the slave it looked pretty shabby so
I used a new rebuild kit I had. Upon bleeding it again I had full pedal
travel. Until it was fully bled. I still have no "oomph" the car goes into
gear
with or without the pedal depressed, and no pwer is reaching the tranny. And I
still haven't been able to set the correct clearences on the master and slave
till I figure why I only have such a short pedal travel. Any help would be
much appreciated.
One thing I did note was when I had the slave off the throw out arm (?) was
not smooth, there was a slight, only slight clunk as it travels. IS this a
matter of the bearing being shot?
Once againm thanks in advance to all who have replied to my dilema.
Terry
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|