Hello List:
Thanks for the replies on the O/D information. Great help as always.
Another question looking for practical hints on fitting liners, pistons &
rod assemblies.
Any order to this re-fitting to keep the figure 8 gaskets in place through
the process?
Fit the gasket, liner - should you use a "hold-down" for the liners?
Feed the piston/rod from the top down.
If the figure 8 gaskets are freshly lathered up with Permatex, do you have
to worry about disturbing them when fitting the new pistons/rods?
The head will go on shortly, so is it likely that the liners & gasket will
be disturbed?
Trying to avoid the "gray oil" after the first fire-up.
Thanks for any help.
Angelo Graham
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|